What convinced us of the merits of epoxy encapsulation was a visit to my friend Steven's house. He has a faering he built with his son that shows the effects of different plywoods and of epoxy coating wood.
You can see three panels in this Faering. The darker plank is Joubert Sapele faced Okoume (varnished), the middle strake is Okoume by Joubert, and the lower plank in the photo is Shelman Okoume. All planks are finished with a Behr spar varnish.
This is the same boat closer up to one of the tanktops. It is Joubert Okoume. The neighboring plank is Shelman Okoume. Both were varnished the same. The tank top is more degraded and molded than the plank. The tank top along the edge of the plank is perfectly clear. This strip was inadvertently epoxy coated when the squeeze out from the glue joint was spread during the clean up process. The same thing happened in the next photo: can you see where the epoxy is?
The results? It is clear that the epoxy coated areas of plywood are making the plywood much more durable and holding up much, much better. The sheer strake is probably holding up better because it is higher in the boat and receives less foot traffic and a lower angle of sunlight upon it. The middle strake and tank tops get more direct sunlight. But the different brands of plywood may have to do with the difference between planks made of Joubert vs Shelman. It is too bad Shelman went out of business. Clearly, Sapele holds up great and Steven made a good decision putting it in as the garboard. With that said, I have also seen Sapele planked boats flake and shed paint after many years and these were boats that were not epoxy coats.
The moral of the story: epoxy encapsulation is a good thing.
0 komentar:
Posting Komentar